Timeline
Jul 19, 2019:
- 2:21 PM Changeset [1184] by
- Modify 2D VSANS NXcanSAS writer to write all data and meta data.
Jul 18, 2019:
- 10:11 AM Changeset [1183] by
- Successfully output 1D VSANS data in NXcanSAS format.
Jul 17, 2019:
- 4:50 PM Changeset [1182] by
- Tie NXcanSAS into reduction methods and add debugging statements.
- 3:14 PM Changeset [1181] by
- VSANS 2D NXcanSAS writer real data from file. Procedure compiles, but not …
- 11:50 AM Changeset [1180] by
- VSANS 1D NXcanSAS writer store real meta data from file. Not fully …
- 9:56 AM Changeset [1179] by
- VSANS 1D NXcanSAS writer created with appropriate data locations, but fake …
Jul 16, 2019:
- 3:11 PM Changeset [1178] by
- changing how the DIV file is generated. Testing out different …
Jul 5, 2019:
- 3:09 PM Ticket #675 (Patch XY panel not updating values) closed by
- fixed: patch XY panel now deletes each file from rawVSANS as it is patched so …
- 3:08 PM Ticket #674 (Trimming is handled differently from MRED or from the Protocol panel) closed by
- fixed: fixed in revision r1177 by explicitly writing out the default trim values …
- 3:06 PM Changeset [1177] by
- fixed a bug where during a reduction using MRED - the beginning/end trim …
- 12:53 PM Ticket #675 (Patch XY panel not updating values) created by
- From Markus -- I used the Patch_x_y_Panel quite intensively in the last …
- 12:52 PM Ticket #674 (Trimming is handled differently from MRED or from the Protocol panel) created by
- From Markus -- This bug concerns the reduction of multiple files, which …
Jul 1, 2019:
- 5:24 PM Changeset [1176] by
- corrected how the raw data panels are displayed in terms of pixels. only a …
Jun 28, 2019:
- 3:30 PM Changeset [1175] by
- Lay ground work for writing VSANS reduced data in the NXcanSAS format.
Jun 26, 2019:
- 9:34 AM Ticket #673 (syntax error while loading NCNR macros) closed by
- fixed: replied by separate email installing v 7.93 will fix this issue …
Jun 22, 2019:
- 12:02 AM Ticket #673 (syntax error while loading NCNR macros) created by
- When loading any NCNR macros, there is always a syntax error window …
Note: See TracTimeline
for information about the timeline view.
